Low-Power-Consumption Integrated PPM Laser Transmitter

Conventional PPM laser transmitters, a CW laser followed by a modulator, are inherently inefficient since the data must be carved from the laser's steady output. 95% of the optical power is discarded in a standard telecom RZ format, with another &#8805; 8x efficiency reduction using a PPM scheme. An alternative is to form the pulse train with a mode-locked laser. However, since the resultant MLL pulse train is periodic, it must produce pulses in every symbol slot, not just once per symbol. This means that for a 32-ary PPM scheme, the MLL optical efficiency is reduced by a factor of at least 32 by discarding the un-needed pulses. In both cases, the electro-optic modulator itself induces an additional 60% optical loss, and requires nearly 0.5W of power to drive. An alternative is to use a low-repetition-rate MLL in combination with a switch fabric to delay each output pulse into the correct PPM slot. However, the use of photonic integrated circuits (e.g., silicon) is prohibitive due to the high intrinsic loss. A 100-MHz PPM data rate scheme requires ~5ns pulse delay. This represents 43-cm propagation in silicon, inducing a power loss &#8805; 10 dB. Adding the loss due to spiraled delay lines, switch junctions, and coupling on/off chip, the aggregate loss of the switch fabric is 18 to 24 dB, representing a significant efficiency loss. RAM Photonics proposes the development of a qualitatively novel approach to high-efficiency, low-bit-rate laser transmitters compatible with space-borne missions. Specifically, we propose to develop a laser transmitter that attains highly efficiency optical data generation by (1) generating only one optical pulse per symbol at arbitrary temporal location, (2) eliminating all electro-optic modulators, and (3) exploiting a nearly lossless fiber architecture. The new transmitter device has low dissipation (< 0.5 W total) and low SWaP footprint, and can operate at arbitrary data rates and generate any symbol formats.