Programmable Disassembler and Reassembler (PDR)

Intelligent Automation, Inc. proposes a novel state of the art Programmable Disassembler and Reassembler (PDR) system. The PDR enables utilization of unused spectral bandwidth by distributing bandwidth over multiple frequencies/paths and then reassembling at the destination with little bandwidth cost. A multilayered protection in reassembly process stops incorrectly reassembling data in the presence of noise and very high latency. The transmitting PDR Disassembler has one input at and at least four outputs at19.2 Kbps to 20 Mbps and the receiving PDR Reassembler has one output and at least four inputs with each input and output at 19.2 kbps through 20 Mbps. The PDR supports data rates lower than 75 bps and higher than 512 Mbps and is programmable to distribute between 0-100% of the input stream to any of the output streams or 100% to one channel or 100% to each channel or non-replicated uneven distribution. The Overhead in framing is maintained no more than 3% to 5% of bandwidth. The novel features will maintain output data rate equal to the input data rate disassembler even in worst case path delay in the SATCOM communication paths.